| T O P I C R E V I E W |
| n/a |
Posted - 28/02/2010 : 09:26:30
I want to make a viv but i dont no what sizes of wood i need for a viv of 3ftx2ftx2ft Please can someone tell me the sizes of wood and the glass
Thanks
Samm |
| 5 L A T E S T R E P L I E S (Newest First) |
| n/a |
Posted - 28/02/2010 : 16:15:57
Egg80 its a bit small
Could you Email me a bigger one at tall-sammy@hotmail.co.uk
|
| n/a |
Posted - 28/02/2010 : 15:02:36
no probs i draw it up for you heres one viv i made out of the bottom of a wall unit 
heres the latest i made built it out of a old comp desk and faces off with timber
heres a rough drawing i did on paint but not that good lol let me know if it dont make sense
[URL=http://s580.photobucket.com/albums/ss249/egg80/?action=view¤t=vivdiagram.jpg] [/URL] |
| n/a |
Posted - 28/02/2010 : 11:00:38
quote:
Originally posted by egg80
what wood are you using?
using 1" thick wood youll need 2 x 3' x 2' for top and bottom, 2 x 2' x 2' for sides which will make your viv 2' wide x 2' high if you want it this high then youll need a back pannel to fit back which should be 3'2" x 2'2" roughly, on the front a lip off the floor of the viv i usually do them at 2" at this youll need a peice 3' x 2" and i usually put a 1" x 3' at the top, put your air vents in the rear they usually are sized at 50 mm but you can also get other sizes but youll need a hole cutter for this, glass buy the glass to fit the viv but be careful when measuring as you have to remember the glass needs to be removable from the rails which just about allow this so needs to be measured to your rails.
hope this helps
paul
Would you be able to draw a picture of all the measurments and post them on here please
Thankss
Samm |
| gmac |
Posted - 28/02/2010 : 10:25:08
hey Samm, got these from the DIY section some of these may help
http://www.thecornsnake.co.uk/forum/topic.asp?TOPIC_ID=6798 |
| n/a |
Posted - 28/02/2010 : 10:03:35
what wood are you using?
using 1" thick wood youll need 2 x 3' x 2' for top and bottom, 2 x 2' x 2' for sides which will make your viv 2' wide x 2' high if you want it this high then youll need a back pannel to fit back which should be 3'2" x 2'2" roughly, on the front a lip off the floor of the viv i usually do them at 2" at this youll need a peice 3' x 2" and i usually put a 1" x 3' at the top, put your air vents in the rear they usually are sized at 50 mm but you can also get other sizes but youll need a hole cutter for this, glass buy the glass to fit the viv but be careful when measuring as you have to remember the glass needs to be removable from the rails which just about allow this so needs to be measured to your rails.
hope this helps
paul |
