| T O P I C R E V I E W |
| Auld Baldy |
Posted - 14/09/2011 : 20:02:05
Here's a PDF of steps for making a simple divider for a viv.
It shows a step by step method of making a card template for the front edge to give a snug fit against the glass. I've only shown a single step for flush fitting runners. If there is a glass top or base fillet, just use the same technique and make allowances.
I suggest using a bit of 5mm foam board. For the pictures I used a scrap sheet of hardboard.
Hope it helps or gives you some ideas. 
http://dl.dropbox.com/u/16008824/CSForum/DividerDIY.pdf.zip |
| 3 L A T E S T R E P L I E S (Newest First) |
| Auld Baldy |
Posted - 15/09/2011 : 03:44:29
Walkthrough done! You can delete this topic.
|
| Auld Baldy |
Posted - 15/09/2011 : 00:01:44
OK K, I'll write up the original list I did for Hissyfit with the images. I'll leave the PDF in as well as it is easier to download for reference. |
| Kehhlyr |
Posted - 14/09/2011 : 23:39:55
Don't suppose you'd like to post the photos and a little walkthrough in a new thread would you??
I'll then move to the DIY section. It deserves a better airing than a PDF.  |
